2
How to prevent wire distortion when high on chest
Look at this picture of me in the 36GG Ewa Michalak HP bra. The wires cannot slope back to where I need them.
Why? Because the bra is too small? Nope. (It is but that's still not why) Because the distance between strap position and wings are too short. When I tighten the straps to the max I prevent wire distortion so that the wires cannot slope back any further than that distance will allow. The fabric in itself prevents wire distortion.
When I wore the bra lower the wires ended way further back.
Now you can take a look at me in the 32H Andorra fit request here: http://www.bratabase.com/troubleshoot/dhirf/.
Those wires are in the perfect spot for me. Also they are not too high. Even if the band is super tight no wires can distort.
I've seen Nesoa saying her arms are in the way for her bra fitting. I now understand how that can be. It's now the same for me. They are in the way because wires become too high, and they are in the way to make wires end where we need them.
Super high on chest bra fitting actually does prevent wire distortion. Say I would now move the strap position in this 36GG HP Nina I would then allow the wires to go 1 or 2 cm further back, not more. That would end them where the wires are in the 32H Andorra. That's not wire distortion. On the contrary they would stay just as stable as now.
I still have to get used to the fact that I have super perky perfectly rounded high on chest boobs. I've never ever seen these boobs in my life. I cannot stop looking at my fitting help request because I cannot even believe what I'm seeing. I cannot understand it was so easy as tightening the straps to the max and just force the bra up to that position. I've been wearing my bras 5-7cm too low.
13 comments
Does this mean you are on the way to bra-joy?
I hope so :D
This thread has 13 comments. Log in to read them