Too picky or just not a perfect fit?
Well, it's about the slight wrinkle once I mentioned in the fitting request again. Today I just made a sketch of the mark that this bra had left. It doesn't run along my IMF at all when my boobs are unsupported. But my breast tissue can approach the sketch as I gave some lift. The bottom of this bra can be filled too when I wear it. So I don't know if this phenomenon can be normal or not for a well fitted bra.
Maybe someone here can help?
Related pictures:
http://bra.pe/IqCM/
http://bra.pe/IqCN/
[Resolved]It fits, but the bra appearance is not so good ...
Well, recently I have lost 2 kilos. Although there is no change on my b. perimet
http://bra.pe/T9h/
Filed under Bras ups and downs
10 comments
Two potential issues come to mind. First, it looks to me that you would actually be between 32E and 32F, and the cups are a bit small for you in this size. You mention having firm tissue, and it’s possible that the wires are too narrow for you, so your firm tissue is pushing the wires down because they’re too narrow. The cup volume might be appropriate, but the wires might be narrow for you. Keep in mind that this might not happen until you’ve worn the bra for a bit and it settles on your body—it might be sitting in your IMF properly when you first put it on. I think this is also what is causing the “wrinkle” in your previous post since the fabric is being strained from too much tissue squeezing into a part of the cup that doesn’t have enough room.
The other possibility might be due to the bottom left or bottom center situations in the below diagram, where the breast is slightly folded over the IMF, creating a space below. This could happen if the cup is too shallow at the fullest part. If you press your breasts against your chest, you may see that the bottom of your breast folds over the IMF. Based on your braless photo and firm tissue this is probably less likely than the first scenario, but possible.
http://i.imgur.com/wuKovXy.png
@belleandblues
Thank you for the reply. According to my trial experiences, I guess the cup width for about 15 cm will be optimal (I think I have wide roots but I don't have very clear root lines so I can only guess). About one year ago, I purchased my first bra (Nadine 3/4) from Change Lingerie. The wire is 15.2 cm wide and fits very comfortably, but unfortunately the cups are too shallow. A few weeks ago I ordered a Comexim Victoria 2HC in 70HH. With some calculations I can figure out that it may have 15.3 cm in cup width and 23.9 cm in cup depth. Hope it will fit.
This thread has 10 comments. Log in to read them